Service area

Need a locksmith in Montgomery County? We come to you

We cover 62 places across Montgomery County.

Call (484) 335-4700 Request a locksmith

A locksmith working on the lock of an open front door at a brick house

Where

Montgomery County

What we cover

Chester County, Delaware County, Montgomery County, Lancaster County and Philadelphia

How we work

We are a mobile locksmith. We come to you.

Working across the county

Montgomery County brings a mix of older homes, newer developments, storefronts, offices, and light industrial spaces, so the hardware changes from place to place. We see rim locks on older entry doors, mortise locks in solid wood doors, and bored cylindrical locks on many newer homes and business doors. Commercial spaces may have heavier deadbolts, storeroom hardware, and panic devices, while apartments and small offices can have simpler setups. The work starts with understanding what is on the door and how that lock was installed.

The kinds of work here

Across the county, we handle rekeying, lock repair, broken key work, lockouts, and replacement of worn hardware. A house door may call for a new deadbolt, a key change, or a lock that no longer turns cleanly. A business job can involve a keyed entry, interior office doors, or a storeroom lock that needs attention. Vehicle work is different again, since the lock is built into the door and the keyway is shaped for that specific car, truck, or van, and the work stays with the vehicle.

How the coverage works

We come to you anywhere in the county and work at the door, the lock, or the vehicle where it sits. That means one stop for a home, another for a storefront, and another for a locked car in a lot, driveway, or other parking place. The setup changes from job to job, but the service stays mobile and direct. Some calls are for a key issue, some for a lock that will not turn, and some for hardware that needs replacement, with the work centered on the lock.

Across Montgomery County

62 places here

32 kinds of work

4 categories

5 areas covered

Worth knowing

In some parts of Montgomery County, we run into older residential doors with mortise locks, tall escutcheons, and trim that has been rebuilt around several rounds of hardware changes. Other homes have bored cylindrical knobs added later, sometimes with worn latch parts and keys that no longer match the hardware cleanly. We also see storefront and mixed-use doors with rim hardware and surface-mounted deadbolts, where the lock body, cylinder, and trim all sit differently from a typical house lock. Each setup calls for a different way of opening the lock and working the hardware on the door.

Some towns in the county have many newer houses with bored cylindrical locks, separate deadbolts, and lever sets that share the same opening, while other areas still have older wood doors with heavier mortise locksets and long plates. We also see apartment and rowhouse doors with narrower profiles, tighter clearances, and hardware that has been changed several times over the years. A worn key may fit one lock in a building and not the next one over, even when the doors look similar from the outside, so we match the work to the lock and the trim on the door.

Commercial doors vary just as much. One property may have a metal door with rim hardware and a panic device, while another has a mortise lock in a narrow storefront door or a bored cylindrical lock paired with a keyed lever. Some spaces use older trim that leaves little room around the cylinder, and some have replacement hardware fitted after earlier repairs. We come to you and open the lock based on the way that door is built, then handle the key and lock body as they sit on that door.